STLVDS3487

The STLVDS3487 is a quad differential line drivers that implements the electrical characteristics of low voltage differential signaling (LVDS). This signaling technique lowers the output voltage levels of 5V differential standard levels (such as TIA/EIA-422B) to reduce the power, increase the switching speeds and allows operations with a 3.3V supply rail. Any of the four current mode drivers will deliver a minimum differential output voltage magnitude of 247mV
into a 100Ωload when enabled.

The intended application of this device and signalling technique is for point-to-point baseband data transmission over controlled impedance media approximately 100Ω. The transmission media may be printed circuit board traces, backplanes or cables. The ultimate rate and distance of data transfer is dependent upon the attenuation characteristics of the media and noise coupling to the environment.

The STLVDS3487 is characterized for operation from -40℃ to 85℃.

Symbol	Parameter	Value	Unit
V_CC	Supply Voltage (Note 1)	-0.5 to 4.6	V
V_I	Input Voltage	-0.5 to (V_CC + 0.5)	V
T_stg	Storage Temperature Range	-65 to +150	℃

Absolute Maximum Ratings are those values beyond which damage to the device may occur. Functional operation under these condition is not implied.

Note 1: All voltages except differential I/O bus voltage, are with respect to the network ground terminal.

· MEETS OR EXCEEDS THE REQUIREMENTS OF ANSI TIA/EIA-644 STANDARD
· LOW VOLTAGE DIFFERENTIAL SIGNALING WITH TYPICAL OUTPUT VOLTAGE OF 350mV AND A 100 Ω LOAD
· TYPICAL OUTPUT VOLTAGE RISE AND FALL TIMES OF 750ps (400Mbps)
· TYPICAL PROPAGATION DELAY TIMES OF 1.7ns
· OPERATES FROM A SINGLE 3.3V SUPPLY
· POWER DISSIPATION 25m W TYPICAL PER DRIVER AT 200MHz
· DRIVER AT HIGH IMPEDANCE WHEN DISABLED OR WITH V_CC =0V
· PIN COMPATIBLE WITH THE MC3487 AND SN65LVD3487
· LOW VOLTAGE TTL (LVTTL) LOGIC INPUT

STL025T		STL05465B	FAST CMOS OCTAL D FLIP-FLOP WITH MASTER RESET
STL10		STL100NH3LL	N-CHANNEL 30V - 0.0032ohm - 25A PowerFLAT (6x5) STripFET III MOSFET
STL100NH3LL.	High Performance E2CMOS PLD Generic Array Logic	STL106	7.6 mm (0.3 inch)/10.9 mm (0.43 inch) Seven Segment Displays
STL106A		STL106B	Flash Memory Card
STL110	1.5A Low Dropout Linear Regulator	STL11NH3LL	Black Surface Seven Segment Displays
STL120NH	Serial/Parallel LED Driver with Current-Regulated, Step-Up DC/DC Converter	STL120NH02V	N-channel 20V - 0.0025ohm - 120A - PowerFLAT(6x5) STripFETIII Power MOSFET
STL120NH02V.		STL130
STL1301250V	SPECIFICATIONS FOR LCD MODULE	STL1304	Multifunction Preset Counter
STL140	Network Interface Device	STL140B	Miniature Aluminum Electrolytic Capacitors
STL141BCT80	Ceramic Capacitors For Mid Voltage SMD	STL141T

Description

Specifications

Features

Pinout

Related Models